Thomas, DaveDaveThomasHopkins, JanetJanetHopkinsAshraf, HumaHumaAshrafPatel, JashJashPatelAnsell, OliverOliverAnsellJourdain, AnneAnneJourdainDe Vos, JoeriJoeriDe VosMiller, AndyAndyMillerBeyne, EricEricBeyne2026-10-292026-10-2920153067-9052https://imec-publications.be/handle/20.500.12860/60658<jats:title>ABSTRACT</jats:title> <jats:p>Wafer backside processing is critical for 3D-IC wafer stacking. Through-silicon vias (TSVs) typically formed using ‘via-middle’ processing, are usually exposed from the backside of 300mm device wafers by the combination of mechanical grinding and wet or dry etch processes. A fast via reveal etch is required to have a productive etch rate, but also to have the precision necessary to control within wafer uniformity, selectivity to thin TSV liners and smoothness of post-etch surfaces. This makes in-situ end-point detection essential for controlled processing, especially as the target tip height is reduced to minimize cost. This paper compares imec’s current wet chemical process of record with SPTS’s dry etch approach. With the dry technique, 1μm nail heights can be controlled within 300nm in order to minimize the overall cost per wafer by eliminating the need for rework steps. The applicability of such a process to extreme wafer thinning to 5μm final Si thickness is also demonstrated.</jats:p>enProceedings paper10.37665/wahyaym33534